- Make sure this fits by entering your model number.
- ☛EASY TO MODIFY FOR CB RADIO USAGE The default frequency 28.000-29.700Mhz (10 meter Radio) if you need it to be CB Radio, to remove soldering will change the radio to 25.615-30.105Mhz(OP1 grounded) or 26.965-27.405 mode(OP1 and OP2 both grounded)
- ☛ GREAT LITTLE RADIO Modulation Mode:AM/FM，It sounds very loud and very clear. Great super small CB radio It is good for fitting in any vehicle or radio shack or atv.It is great for a holiday road trip or for local traffic reports.
- ☛.Power output:8 Watts FM/AM. Please send the email to seller (us) if you need the instruction documents for changing 11 meter Radio cb radio band
- 4.Frequency Control:PLL Synthesizer With push-to-talk/UP/DN and coiled cord.AnyTone Smart 10 Meter Radio can convert into 11 meter CB Radio Kit 40 Channel for truck
- ☛WARRANTY 1 year warranty. Money back if you are not satisfied with it in 1 month. Please feel free to contact with us if you have any query. We will give you prompt reply and good after service
GENERAL
Modulation Mode:AM/FM
Frequency Range:28.000-29.695MHz
Frequency Tolerance:0.005%
Input Voltage:13.2V
Dimensions:104*109*25mm
Weight:421g
Frequency control:PLL Synthesizer
Operating Temperature range:-20℃ to +50 ℃
Current Drain: Transmit: with push-to-talk/UP/DN and coiled cord,Receive: 2A MAX,VOL Max:Squelched 0.3A
Weight:0.8A
Antenna Connector:UHF,SO-239
TRANSMITTER
Power Output:8 Watts FM/AM
Transmission interference:inferior to 4nW(-54dBm)
Frequency Response:300-3000Hz
Modulated signal distortion: inferior to 5%
Output Impedance:50 ohms
RECEIVER
Sensitivity:Less than 1uV for 10dB(S+N)/N
Image Rejection: 70dB
Adjacent Channel Rejection:60dB
IF Frequencies:1st 10.695Mhz 2nd 455KHz
Automatic Gain Control(AGC):Less than 10dB change in audio,output for inputs from 10 to 50000uV
Squelch:less than 1uV
Audio Output power:1 Watts
Frequency Response:300-3000Hz
AnyTone Smart 10 Meter Radio can convert into 11 meter CB Radio Kit 40 Channel for truck
WARNING
1.)Your equipment is protected against an inversion of polarities. However, before switching it on, you are advised to check all the connections. Your equipment must be supplied with a continued current of 12 volts (A)
2.)Lorries generally have two batteries and an electrical installation of 24 volts, in which case it will be necessary to insert a 24/12 volt converter into the electrical circuit. The following connection steps should be carried out with the power cable disconnected from the set. a.)Check that the battery is of 12 volts. b.) Locate the positive and negative terminals of the battery (+ is red and – is black). Should it be necessary to lengthen the power cable, you should use the same or a superior type of cable.